|
Door Trim Welt By Octavio Diaz |
This is a very simple and inexpensive mod that adds a very classy touch to the doors. It consist of using extruded welt or piping material to stuff in the the channel of the door betwen the leather and the plastic door panel. Each door requires 80" of welt. The installation is very simple and will take less then 15 minutes. even if you take your time.
 The welt material is simply pushed into the channel. It fits a little loose but will stay in there once it is installed. Start in the lower edge of the door right above the door reflector. |
 Push the material in the channel and work your way completely around the door. When you get back to the reflector, cut the excess and push the remaining welt into the channel so the two ends are completely flush. |
 When the two ends are pushed in, the joint is barely noticeable. |
 The finished product is a marked improvement over the stock doors. |
This material is available in a variety of colors and can be chosen to either match your body color or the silver tinsel which matches the aluminum color in the IUP dash.
The extruded door welts can be ordered from Mr. Mikes. He has a minimum order but even with the minimum order, this is still a very inexpensive and worth while modifcation.
   |